Toilet Repair — Croydon
Toilet Repair in Croydon
Experienced plumbers repairing running toilets, failed flush valves, blocked toilets, and leaking pan seals across Croydon — Croydon, Purley, Thornton Heath, Norbury. Same-day attendance available. All repairs quoted before work begins.
Toilet repairs in Croydon
What we fix
Running toilet repair
A toilet that runs continuously wastes 200 to 400 litres per day and adds significantly to your water bill. We diagnose and repair failed flush valves, faulty fill valves, and worn siphon diaphragms on the same visit.
Flush valve replacement
Drop valve seals on modern cisterns fail over time, causing a slow trickle into the pan or continuous flushing. Replacement takes 30 to 60 minutes. Cost from £80 to £120 including parts.
Fill valve replacement
If the cistern does not refill after flushing, or refills too slowly, the fill valve (ballcock or float valve) has failed. Replacement is a 30-minute job from £60 to £100 including parts.
Blocked toilet
We clear blocked toilets using manual clearing rods and, where required, a drain auger. For persistent blockages, a CCTV drain survey identifies the root cause further down the drain.
Pan seal replacement
Water appearing at the base of the toilet after flushing indicates a failed wax ring or push-fit pan connector. We remove the toilet pan, replace the seal, and inspect the floor for water damage.
Wall-hung toilet service
Wall-hung toilets with concealed cisterns (Geberit, Grohe, Viega frames) require removal of the access panel. We service concealed cisterns, replace flush valves and fill valves, and refit the panel on completion.
Areas in Croydon we cover
Common toilet faults in Croydon
How toilets fail and how we fix them
Running toilet — cistern fills and refills continuously
A running toilet is the most common toilet fault we attend across London. The cistern fills to the overflow level and then water trickles continuously into the pan, or the cistern refills in short bursts throughout the day. This wastes 200 to 400 litres per day — a significant cost at current Thames Water metered rates.
The cause is almost always a failed flush valve flapper or drop valve seal, or a faulty fill valve that does not shut off at the correct water level. London hard water accelerates wear on valve seals — calcium deposits build up on the rubber seal faces and cause them to leak. Most running toilet repairs are completed within 30 to 60 minutes on the first visit.
Toilet not flushing
On older UK siphon cisterns, the siphon diaphragm (a plastic or rubber disc) wears and cracks, preventing the siphon action that draws water out of the cistern. On modern close-coupled cisterns with drop valves, the valve seal fails and the cistern either does not flush or produces a weak flush. Both repairs are simple and inexpensive — typically completed in under 30 minutes.
Toilet rocking or loose at the base
A toilet that rocks when sat on has failed floor fixings or, in older London properties with solid floors, a deteriorated lead flashing seal at the base. Persistent rocking causes the pan connector to work loose and can lead to water leaking at the base. We re-anchor the toilet and inspect the pan connector and floor for water damage.
Leaking cistern and overflow pipe dripping
An internal overflow — where water runs down the overflow pipe to the outside of the building — indicates the fill valve is not shutting off. This is a fill valve fault. A drip at the cistern-to-pan connector (the large nut connecting the bottom of the cistern to the pan) indicates a failed doughnut washer at that joint. Both are straightforward repairs.
Flush valve types: siphon vs drop valve
Traditional UK close-coupled cisterns use a siphon mechanism — water is drawn up through a siphon by pressing the handle, then gravity empties the cistern. Siphon cisterns are very reliable but slower to refill. Modern cisterns use a drop valve — a direct-flush mechanism that opens a valve at the bottom of the cistern. Drop valves flush faster but the seal is more prone to failure, particularly with hard London water.
Concealed cisterns (behind a wall panel in wall-hung installations) almost always use drop valves. These require access to the panel to service. We work with all major concealed cistern frames including Geberit Duofix, Grohe Rapid SL, and Viega Prevista.
Leaking at the base — pan seal failure
If water appears at the base of the toilet pan after flushing, the wax ring seal or push-fit pan connector between the toilet pan and the soil pipe has failed. This repair requires removing the toilet pan entirely, replacing the pan connector or wax ring, and refitting the toilet. The floor beneath should be inspected for water damage — wet timber floors or damaged tiles may require additional remediation work.
Pricing in Croydon
Toilet repair costs
Call-out charge
From £80
Flush valve replacement
£80 – £120
Fill valve replacement
£60 – £100
Siphon diaphragm replacement
£60 – £90
Pan seal replacement
£120 – £200
New toilet supply and fit
£200 – £400
All prices include labour and standard parts. Prices are indicative — a fixed price is confirmed before any work begins.
180+ verified reviews
Trusted by London homeowners
60 reviews
Checkatrade.com
120 reviews
MyBuilder.com
Common questions
Toilet repair Croydon: frequently asked
Why is my toilet running constantly
A constantly running toilet is almost always caused by a failed flush valve seal or a faulty fill valve that does not shut off at the correct water level. In Croydon, London hard water causes calcium build-up on valve seals, accelerating wear. The repair is straightforward — most running toilets are fixed on the first visit within 30 to 60 minutes.
How much does toilet repair cost in London
Toilet repair in Croydon starts from £80 for a call-out. Flush valve replacement costs £80 to £120. Fill valve replacement costs £60 to £100. Pan seal replacement (toilet base leaking) costs £120 to £200. A new toilet supply and fit costs £200 to £400. All prices are confirmed before work begins.
Can you fix a running toilet on the same day
Yes — we offer same-day toilet repair across Croydon, covering Croydon, Purley, Thornton Heath, Norbury and all surrounding areas. We carry flush valve kits, fill valves, and siphon diaphragms on our vehicles, so most toilet repairs are completed on the first visit without the need to order parts.
Is it worth repairing an old toilet
Most toilet repairs are cost-effective regardless of the age of the toilet. Flush valves, fill valves, and siphon diaphragms are standard parts available for most toilet models. If the toilet is a discontinued style or requires repeatedly sourcing expensive bespoke parts, we will advise whether a full replacement would be more economical. New toilet supply and fit in Croydon costs from £200 to £400.
Other London boroughs